ISDN Simulator - responder behaviour
Responder under "Yes " condition
Q931 call simulation in Responder behaviour set to
"Yes" accepts any incoming SETUP and process the following state:
- Establish state: transmits the Q931 messages (CALL PROC...)
connect the "Establish source" B channels: and then transmits
the CONNECT after a delay.
- Connect active data source specified by "If IE present in incoming SETUP
mode"
- 1 to 15 IE's and specific active source definition for each of them.
- 1 to 15 IE's and a single active source definition for each of
them (OR condition).
- Connect active data source specified by " If called
number of incoming call is"
- 1 to 15 "called number" and specific active source definition for each of them.
- 1 to 15 "called number" and a single active source definition for each of
them (OR condition).
- Call Clearing state at the end of "Data state duration"
delay. The Q931 messages RELEASE COMPLETE is transmitted if selected
Responder under "No " condition
Q931 call simulation in Responder behaviour set to
"No" rejects any incoming SETUP and process the following state:
- Call Clearing state. The Q931 messages RELEASE COMPLETE is
transmitted if selected
Responder under "if IE "condition
Q931 call simulation in Responder behaviour can be
carried out according to whether or not IE's with particular content are present in the
SETUP message of the incoming communications. Then, the profile is specified at least with
one of the following parameters:
- Accept incoming calls: If IE in SETUP (Responder behaviour).
- Specification of 1 to 8 IE's with OR condition.
- Connect active data source specified by "If IE present in incoming SETUP
mode"
- 1 to 15 IE's and specific active source definition for each of them.
- 1 to 15 IE's and a single active source definition for each of
them (OR condition).
- Connect active data source specified by " If called
number of incoming call is"
- 1 to 15 "called number" and specific active source definition for each of them.
- 1 to 15 "called number" and a single active source definition for each of
them (OR condition).
The simultaneous specification of Responder if IE and Connect
active source if IE can result in the implementation of an AND condition.
| 